The following error codes indicate that a non‑genuine Lexmark cartridge is installed:
32.13
32.16
32.19
32.22
32.25
32.28
32.31
32.34
32.37
For more information, see
“Using genuine Lexmark parts and supplies” on page 250.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section or visit
www.lexmark.com.
Replace wiper
Try one or more of the following:
• Replace the fuser wiper in the printer.
• Touc h Continue to clear the message and continue printing.
Restore held jobs?
Try one or more of the following:
• From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk.
• From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs.
Scan document too long
The scan job exceeds the maximum number of pages. Touch Cancel job to clear the message and cancel
the scan job.
Scanner automatic feeder cover open
Close the ADF cover.
Scanner disabled by admin [840.01]
Print without the scanner, or contact your system support person.
Troubleshooting 306
To Next Page
Loading...
