Use To
Scan edge to edge
O
On
Specify whether the original document is scanned edge-to-edge.
Note:
O
is the factory default setting.
Sharpness
1–5
Adjust the amount of sharpness on a scanned image.
Note: 3 is the factory default setting.
Temperatur e
‑4 to 4
Specify warm or cool outputs. Cool values generate a bluer output than the
default while warm values generate a redder output than the default.
Note: 0 is the factory default setting.
Print Settings
Use To
Copies
1–999
Specify a default number of copies for each print job.
Note: 1 is the factory default setting.
Paper Source
Tray [x]
Multipurpose Feeder
Manual Paper
Manual Envelope
Set a default paper source for all print jobs.
Note: Tray 1 is the factory default setting.
Collate
(1,1,1) (2,2,2)
(1,2,3) (1,2,3)
Stack the pages of a print job in sequence when printing multiple copies.
Note: (1,2,3) (1,2,3) is the factory default setting.
Sides (Duplex)
1 sided
2 sided
Enable two-sided printing for incoming print jobs.
Note: 1 sided is the factory default setting.
Staple
O
On
Specify whether prints are stapled.
Notes:
• O is the factory default setting.
• This menu item appears only when a staple
finisher
is installed.
Hole Punch
O
On
Specify whether prints have punched holes.
Notes:
• O is the factory default setting.
• This menu item appears only when a supported staple, hole punch finisher is
installed.
Hole Punch Mode
2 holes
3 holes
4 holes
Specify the number of holes to be made on the prints.
Notes:
• 3 holes is the U.S. factory default setting. 4 holes is the international factory default
setting.
• This menu item appears only when a supported staple, hole punch
finisher
is
installed.
Understanding the printer menus 220
To Next Page
Loading...
