Lexmark XM7200 Series - Page 226

Use To
Staple Job
O
On
Specify whether printed output is stapled.
Notes:
• O is the factory default setting.
• This menu item appears only when a supported staple finisher is
installed.
Run Stapler Test Print a report that confirms that the staple finisher is functioning properly.
Note: This menu item appears only when a supported staple
finisher
is
installed.
Hole Punch
On
O
Specify whether holes will be created on printed outputs for the purpose of
collecting the sheets in a binder or folder.
Notes:
•
O
is the factory default setting.
• This menu item appears only when a supported staple, hole punch
finisher is installed.
Hole Punch Mode
2 holes
3 holes
4 holes
Specify the number of holes to be created on printed outputs for the purpose
of collecting the sheets in a binder or folder.
Notes:
• “3 holes” is the U.S. factory default setting. “4 holes” is the international
factory default setting.
• This menu item appears only when a supported staple, hole punch
finisher is installed.
Oset Pages
None
Between Copies
Between Jobs
Oset pages at certain instances.
Notes:
• None is the factory default setting.
• Between Copies osets each copy of a print job if Collate is set to “(1,2,3)
(1,2,3).” If Collate is set to “(1,1,1) (2,2,2),” then each set of printed pages are
oset, such as all page 1's and all page 2's.
• Between Jobs sets the same oset position for the entire print job
regardless of the number of copies printed.
• This menu item appears only when a supported staple finisher is
installed.
Quality menu
Use To
Print Resolution
300 dpi
600 dpi
1200 dpi
1200 Image Q
2400 Image Q
Specify the printed output resolution in dots per inch.
Note: 600 dpi is the factory default setting.
Understanding the printer menus 226