Wait several seconds for the install screen to appear.
Note: If the install screen does not appear automatically, click Start Run, and then type D:\setup.exe, where
D is the letter of your CD-ROM drive.
3 Follow the instructions on the computer screen to set up the printer.
Your security software may notify you that Lexmark software is trying to communicate with your computer
system. Always allow these programs to communicate. This is necessary for the printer to work properly.
Setting up the printer on a Macintosh operating system
1 Unpack the printer.
Note: Contents, such as the number of print cartridges, may vary by model.
1
2
3
1
2
3
5
7
6
8
4
10
To Next Page
Loading...
