99
2
2-1. Instrument cluster
Vehicle status information and indicators
2 Press the “ODO TRIP” switch to
change the odometer and trip meter
display to odometer.
3 Turn the power switch off.
4 While pressing and holding the “ODO
TRIP” switch, turn the power switch to
ON mode.
5 Continue to hold the “ODO TRIP”
switch for approximately 5 seconds,
and then release it once the odometer
begins flashing.
Updating is complete once the odometer
flashes for approximately 5 seconds and
then the display returns to normal.
Q Outside temperature display
O In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
O When “--” or “E” is displayed, the system
may be malfunctioning. Take your vehicle
to any authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
Q Liquid crystal display
P.108
Q Customization
The gauges and meters can be customized
on of the multi-information display.
(P.111)
Q Display items
Odometer
Displays the total distance the vehicle has
been driven.
Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
display different distances independently.
Distance until next engine oil
change
Displays the distance the vehicle can be
driven until an oil change is necessary.
Q Changing the display
Each time the “ODO TRIP” switch is
pressed, the displayed item will be
Q The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver’s shifting and the new gear num-
ber appearing on the display. This lag
could cause the driver to downshift
again, causing rapid and excessive
engine braking and possibly an accident
resulting in death or injury.
Q To prevent damage to the engine and
its components
O Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
O The engine may be overheating if the
engine coolant temperature gauge is
in the red zone (H). In this case, imme-
diately stop the vehicle in a safe place,
and check the engine after it has
cooled completely. (P.448)
Odometer and trip meter dis-
play
To Next Page
Loading...
