Child restraint system installation method (except for Puerto Rico)
Child restraint system fixed with a child restraint LATCH anchor
WARNING
■ When installing a child restraint system
Observe the following precautions. Failure to do so may result in death or serious injury.
● When using LATCH anchors, make sure that the area around the anchors is free of
objects and that the seat belt will not be caught behind the child restraint system.
● Follow all installation instructions provided by the child restraint system manufacturer.
● Never attach two child restraint system attachments to the same anchor. In a collision,
one anchor may not be strong enough to hold two child restraint system attachments
and may break. If the LATCH anchors are already in use, use the seat belt to install a
child restraint system in the center seat.
● When securing some types of child restraint systems in rear seats, it may not be
possible to properly use the seat belts in positions next to the child restraint without
interfering with it or affecting seat belt effectiveness. Be sure your seat belt fits snugly
across your shoulder and low on your hips. If it does not, or if it interferes with the child
restraint, move to a different position. Failure to do so may result in death or serious
injury.
● If the seat is adjusted, reconfirm the security of the child restraint system.
Laws and regulations pertaining to anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to SAE J1819.
With rigid lower attachments
LATCH anchors are provided for the each rear seat. (Buttons displaying the
location of the anchors are attached to the seats.)
1-3. Preparations for safe driving with children in the vehicle
39
1
Before driving
To Next Page
Loading...
