17
RZ450e_RZ300e_QG_U
1
Stop the vehicle completely.
2
Set the parking brake.
Check the parking brake indicator is illuminated.
3
Press the P position switch.
Check that the shift position indicator shows P and the parking brake indicator is illumi-
nated.
4
Press the power switch shortly and firmly.
The EV system will stop, and the meter display will be extinguished (the shift position
indicator will be extinguished a few seconds after the meter display).
5
Release the brake pedal and check that “ACCESSORY” or “POWER ON” is not
shown on the meter.
Modes can be changed by pressing the power switch with brake pedal released. (The mode
changes each time the switch is pressed.)
1
OFF
The emergency flashers can be used.
2
ACC*
Some electrical components such as
the audio system can be used.
“ACCESSORY” will be displayed on
the meter.
3
ON
All electrical components can be used.
“POWER ON” will be displayed on the
meter.
*: ACC mode can be enabled/disabled on
the customize menu.
Stopping the EV system
Changing the power switch mode
To Next Page
Loading...
