16
RZ450e_RZ300e_QG_U
When Driving
1
Check that the charging cable is disconnected.
2
Pull the parking brake switch to check that the parking brake is set.
The parking brake indicator will come on.
3
Firmly depress the brake pedal.
and a message will be displayed on the multi-information display. If it is not dis-
played, the EV system cannot be started.
When the shift position is N, the EV system cannot start. Shift the shift position to P
when starting the EV system.
4
Press the power switch shortly and
firmly.
When operating the power switch, one
short, firm press is enough. It is not nec-
essary to press and hold the switch.
If the “READY” indicator turns on, the
EV system will operate normally.
Continue depressing the brake pedal
until the “READY” indicator is illumi-
nated.
The EV system can be started from any
power switch mode.
5
Check that the “READY” indicator is
illuminated.
The vehicle will not move when the
“READY” indicator is off.
Starting the EV system
Performing the following operations when carrying the electronic key on your person
starts the EV system or changes power switch modes.
Starting the EV system
To Next Page
Loading...
