33
RZ450e_RZ300e_QG_U
■
Changing to the high beams
Push the lever forward.
The AHB indicator will turn off and the high
beam indicator will turn on.
Pull the lever to its original position to
enable the Automatic High Beam system
again.
■
Changing to the low beams
Press the Automatic High Beam switch.
The AHB indicator will turn off.
Press the switch to enable the Automatic
High Beam system again.
Pull the lever rearward and then return it to
its original position.
The high beams will illuminate while the
lever is pulled, however, after the lever is
returned to its original position, the low
beams will remain on for a certain amount
of time. After this, the Automatic High
Beam system will operate.
Turning the high beams on/off manually
Temporarily switching to the low beams
To Next Page
Loading...
