LG 32LK450 - ADC Process

LG Electronics Inc. Display Division
Establish :
Reform :
LC01U Adjust specification
LG(56)C2-0789-00
3.1 ADC Process
3.1.1. ADC
※ You need not connecting component and RGB(D-sub) cable.
Because ADC uses TV internal pattern
■ Enter ‘EZ ADJUST’ mode by pushing ‘ADJ’ key.
■ Enter ADC Calibration mode by pushing ‘OK’ or ‘►’ key after selecting ‘6. ADC Calibration’
ADC Calibration
ADC Comp 480i NG
ADC Comp 1080p NG
ADC RGB NG
Start Reset
EZ ADJUST
0. Tool Option1
1. Tool Option2
2. Tool Option3
3. Tool Option4
4. Tool Option5
5. Country Group
6. ADC Calibration ▶
7. White Balance
8. 10 Point WB
9. Test Pattern
10. EDID D/L
11. Sub B/C
12. V-Com
13. P-Gamma
 Caution : Turn on TV by pushing ‘POWER ON’ or ‘P-ONLY’ key
※ ADC Calibration Protocol (RS-232)
NO Item CMD 1 CMD 2 Data 0
Enter
Adjust MODE
Adjust ‘Mode In’
A A 0 0
When transfer the ‘Mode In’,
Carry the command.
ADC adjust ADC Adjust
A D 1 0
Automatically adjustment
(The use of a internal pattern)
Adjust Sequence
▪aa 00 00 [Enter Adjust Mode]
▪xb 00 40 [Component1 Input (480i)]
▪ad 00 10 [Adjust 480i Comp1]
▪xb 00 60 [RGB Input (1024*768)]
▪ad 00 10 [Adjust 1024*768 RGB]
▪aa 00 90 End Adjust mode
※ Required equipment : factory SVC remocon.
LG electronics