LG 32LK450 - Auto-Control Interface and Directions; Auto Adjustment Map; Manual W;B Process

LG Electronics Inc. Display Division
Establish :
Reform :
LC01U Adjust specification
LG(56)C2-0789-00
LG electronics
Auto-control interface and directions
1. Adjust in the place where the influx of light like floodlight around is blocked. (illumination is less than
10ux).
2. Adhere closely the Color Analyzer (CA210) to the module less than 10cm distance, keep it with the surface
of the Module and Color Analyzer’s Prove vertically.(80~100°).
3. Aging time
-. After aging start, keep the power on (no suspension of power supply) and heat-run over 15 minutes.
-. Using ‘no signal’ or ‘full white pattern’ or the others, check the back light on.
 Auto adjustment Map(RS-232C)
Equipment Æ Wireless unit Wireless unit Æ Set
Index
CMD1 CMD2 Set ID Data CMD1 CMD2 CMD3 CMD4
Start w b 0 00 1F 04 00 00
Gain start w b 0 10 1F 04 00 10
Gain End w b 0 1F 1F 04 00 1F
Offset Start w b 0 20 1F 04 00 20
Offset End w b 0 2F 1F 04 00 2F
End w b 0 FF 1F 04 00 FF
RS-232C COMMAND
[CMD ID DATA]
CENTER
(DEFAULT)
Cool Mid Warm
MIN
Cool Mid Warm
MAX
R Gain jg ja jd 00 172 192 192 192
G Gain jh jb je 00 172 192 192 192
B Gain ji jc jf 00 192 192 172 192
R Cut 64 64 64 128
G Cut 64 64 64 128
B Cut 64 64 64 128
** Caution **
Color Temperature : Cool, Medium, Warm.
One of R Gain/G Gain/ B Gain should be kept on 0xC0, and adjust other two lower than C0.
(when R/G/B Gain are all C0, it is the FULL Dynamic Range of module)
*
Manual W/B process using factory SVC remocon.
■ Enter ‘EZ ADJUST’ mode by pushing ‘ADJ’ key.
■ Enter White Balance mode by pushing ‘OK’ or ‘►’ key after selecting ‘7.White Balance’.