Using additional options
Adjusting aspect ratio
Resize an image to view at its optimal size by
pressing RATIO while you are watching TV.
You can also change the image size by
pressing Q. MENU or accessing Aspect
Ratio in the PICTURE menus.
You can adjust the enlarge proportion
using the Navigation buttons.
You can only select
4:3
,
16:9, 14:9
,
Cinema Zoom in Component mode.
You can only select 4:3, Original, 16:9,
14:9, Cinema Zoom in HDMI mode.
You can only select 4:3
,
16:9 in
RGB-PC,
In DTV/HDMI/Component (over 720p)
mode, Just Scan is available.
In DTV mode, Full Wide is available.
NOTE
mode only.
- 16:9: Resizes images to fit the screen width.
- Just Scan: Displays video images in the origi-
nal size without disappearing parts at the edge
of the image.
If you select Just Scan, you may see
image noises at the edge of the original
signal.
NOTE
- 4:3: Resizes images at the standard 4:3 with-
out distortion.
-
Full Wide: When TV receives the wide
screen signal,it will lead you to adjust the
picture horizontally or vertically, in a linear
proportion,to fill the entire screen fully.
4:3 and 14:9 video is supported in full screen
without any video distortion through DTV
input.
-
Original: When your TV receives a wide
screen signal it will automatically change to the
picture format broadcast.
To Next Page
Loading...
