15
INSTALLATION
ENGLISH
Installing the Charging
Station
Installation
Follow the steps below to install the charging
station on a hard and level floor.
• Do not install on carpeted floors or rugs. The
product may fall, causing injury or damage.
1
Place the product on a flat, hard surface.
• During installation, allow 5cm clearance in
the the rear and a radius of 20cm to the front
& sides to be able to open both doors of the
product.
• When storing with the mop nozzle, install
the product further away from the wall.
2
Using the anti-tip kit, fix the product firmly to
the wall.
• You may need to seek professional help to
assist with securing product to wall using
anti-tip kit.
3
Plug the power plug into the outlet.
• When the power plug is connected correctly,
the status display flashes, and the product
setting is initialized. Once initialization is
completed, the status display turns off.
• Use a velcro tie to bind and tidy the excess
cable.
Anti-tip Kit Installation
Anti-tip kit is intended to secure the product to the
wall firmly in order to prevent the product from
falling over or tipping,which may lead to personal
injury, or product or floor damage. Install and use
the kit in the following manner.
• Carefully read and follow the guidelines in order
to prevent property damage or personal injury.
• Do not lean against the product or place a heavy
object on top of it.
5 cm
20 cm
To Next Page
Loading...
Need help?
General
