-14-
How to use
Note about using the product
What to be aware of about using the product
•
Make sure that the dust bin lid is on prior to using the
product. Otherwise, suction strength will deteriorate
and cleaning will not be satisfactory.
•
Support the bottom of the product when cleaning an
elevated surface.
•
While leaving the product unattended or not using the
product for extended period, make sure to properly put
it in the charging station or lie it on a floor. Otherwise,
the product may fall and get damaged or cause injury
to people.
•
Make sure that the exhaust filter is properly assembled
before using the product.
•
Environmental conditions such as temperature and hu-
midity may cause static on the product. Please contact
the customer service of LG Electronics if a same issue
persists.
•
Any foreign object on the inlet port or extension pipe
will prevent the product from proper operation. Make
sure to remove any foreign object such as a sock or
stocking before using the product.
•
Battery life will be shortened after using the product
for extended period thanks to its nature.
•
When battery is about to get fully discharged, the last
block on the battery indicator starts to flash and the
product will power off after a while. Fully charge the
battery in this case.
•
Please use the product at room temperature as the
battery life will deteriorate severely if used at tempera-
tures lower than 5℃ or higher than 38℃ for an extend-
ed period of time.
Using the product
1
Assemble the body, extension pipe, inlet, and battery
in that sequence.
제품 연결 버튼
연장관 길이 조절 버튼
Inlet port
Extension pipe
Battery
Product
body
2
Press the button on the extension pipe to adjust its
length.
•
The pipe has 4 lengths.
Extension pipe
length button
3
Attach the inlet to the body or extension pipe.
Extension pipe
4
Care
•
Using the product for a long time with the accessory
inlet port attached may overburden the motor.
•
Using the accessory inlet port on a TV, monitor or LCD
display may leave a scratch on the surface.
•
Apply caution to avoid getting your finger stuck in a
gap.
•
Any foreign object sucked during cleaning in the inlet
will stop the inlet in order to prevent damage to the
body or inlet. Remove the object before resuming
cleaning.
To Next Page
Loading...
Need help?
General
