LG CordZero A9 Series - Removing Charging Station PCB

-25-
6. Removing charging station PCB
(1) Loosen the 3 screws from
the base.
(2) Remove the screw from
the groove in the red circle.
(3) Remove the base cover
after removing the screw.
(4) Inside of the charging
station
(5) Remove the terminals of
the charging station.
(6) Remove the bump inside
the terminals and take out
the PCB.
(7) Remove the harness
connector and replace the
PCB.
(8) Reassemble in the reverse
sequence.
Disassembly, assembly and repairing of main parts