Operating 27
Operating
3
P-BOOK
LIST
Checks the list of the phone numbers saved by
phonebook.
SEARCH
Searches the phone number in the list.
GET
Getting the phonebook from the phone
automatically. This menu is only available on phones
with PBA / PBAP (Phone Book Access Pro le).
CONNECT
LIST
Checks the list of the Connected Device Name.
SEARCH
Searches the phones available to connect. The
Connected Device Name is displayed on the top.
SETUP
VISIBLE
Makes it is impossible to search this unit.
(SHOWN <-> HIDDEN)
AUTO CON
Adjusts connection with automatically or not.
(ON <-> OFF)
AUTO ANS
Adjusts answering automatically or not.
(MANUAL <-> AUTO)
MIC VOL
Adjusts microphone volume on the phone
from 1 to 5. While you are on the phone with
Bluetooth wireless technology, press
A
/
D
(or
c
/
v
on the remote control) to adjust the
MIC volume.
REDIAL
Adjusts the counts of redial. (1 TIME <-> 2 TIMES)
INFO
NAME
Changes the name of this unit.
ADDRESS
Checks the address.
PIN-CODE
Changes the PIN code. Default is 1234.
WICS (Wireless Controller &
Synchronization)
You can control the unit by using the "WICS"
application.
1. Search the “WICS” application and install it.
[Displays installed "WICS" application]
2. Pairing links your unit and iPhone with
Bluetooth wireless technology. (Refer to the
page 24.)
3. When you run the “WICS” application, activating
source is displayed after initial screen. Then you
can control the unit on iPhone.
[Initial screen] [Tuner screen]
- You can select a source by pressing "SOURCE".
[Source Mode screen]
To Next Page
Loading...
Need help?
General
