LG LFXS24623B - Main PCB; Dispenser; Display PCB; Ice Button Replacement

3-9 MAIN PCB
1) Loosen 3 screws on the PWB cover.
3-10 DISPENSER
1) Pull out the drain
2) Remove the PCB cover
3) Disconnect wire harness and replace the main PCB in
the reverse order of removal.
3-11 DISPLAY PCB
As shown below, remove 1 screw on the PCB fixing screw.
Remove the display PCB fixing screw.
3-12 ICE BUTTON ASSEMBLY
1) Remove the 1 screw holding the lever.
2) Remove the spring from the hook.
3) Push and pull on the tab to remove.
CAUTION: When replacing the dispenser cover make
sure the lead wire does NOT come off and the water line
is not pinched by the dispenser.
Case, PCB
Button Lever
Display PCB
Figure 20
Figure 21
Figure 22
Figure 23 Figure 24
Figure 25
Figure 30
Figure 28
Case, PCB Display PCB
Figure 29
Figure 28
2) Use these 2 holes to pull
out the bottom
3) If nozzle is interfered with button, push and pull out the
bottom of button and then pull out the right side.
4) Holding the inner side of
the dispenser pull
forward to remove.
5) Remove the
lead wire.
Figure 26 Figure 27