Operating18
Operating
3
Radio Operations
Be sure to fully extend the FM wire antenna.
Listening to the radio
1. Press F until radio frequency appears in the
display window.
The last received station and “FM” appear on the
display window.
2. Auto tuning :
Press and hold TUNING +/- on the remote
control or
C
/
V
on the unit for about two
seconds until the frequency indication starts to
change, then release. Scanning stops when the
unit tunes in a station.
Or
Manual tuning :
Press TUNING+/- on the remote control or
C
/
V
on the unit repeatedly.
3. Adjust the volume by pressing VOL +/-.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press F until radio frequency appears in the
display window.
2. Select the desired frequency by pressing
TUNING +/- on the remote control or
C
/
V
on the unit.
3. Press MEMORY on the remote control. A preset
number will blink in the display window.
4. Press PRESET
W
/
S
on the remote control to
select the preset number you want.
5. Press MEMORY on the remote control. The
station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET
W
/
S
on the remote control.
Deleting all the saved stations
1. Press DELETE on the remote control.
“dEL”, “ALL” will flash up alternately on the unit
display.
2. Press DELETE on the remote control to erase all
the saved radio stations. “dELETEd ALL ” will be
displayed on the unit display.