10-3
Copyright © LG Electronics Inc. All rights reserved.
Only training and service purposes
TROUBLE SHOOTING
Oven door sagging on one
side
Door does not close
completely at top
Door glass breaks.
Damaged oven door gasket.
Oven racks fit too tight.
Oven smokes/odor first few
times of usage
Excessive smoking during a
Self clean cycle
Convection fan make a
noise
Failures Codes
Oven temperature too hot
or too cold
• Hinge loose or out of position to
oven liner
• Broken or misadjusted door spring
• Door fits too tight at bottom.
• Oven racks covered with foil.
• Glass installed backward.
• Improper Self clean
• Racks were cleaned in self clean
cycle
• Tolerance buildup in oven liner.
• This is normal
• Excessive soil
• A convection fan may
automatically turn on and off.
Low level noise is normal
• Loose nut of convection fan
• Deformed convection fan
• Electronically controlled
• Oven sensor needs to be adjusted
• Adjust hinges or replace hinges
• Adjust or replace hinges
• Adjust hinges outward.
• Do not cover racks with foil.
• Install tempered glass toward the heat.
• Do not use harsh abrasives or scouring
pads. See Owner’s manual intructions
• Apply a small amount of vegetable oil to a
paper towel and wipe the edges of the
oven racks with the paper towel. Do not
spray with pam or other lubricant sprays.
• Notify customer Assurance department.
• Minor smoking or odor is normal for the
first few tikes of oven usage
• Ventilate area well and perform self clean
cycle
• Press the CLEAR/OFF pad. Open the
windows to rid the room of smoke.
Wait until the Self Clean cycle is cancelled
Wife up the excess soil and reset the
clean
• Low level noise is normal
• Re-fasten the nut
• Replace the convection fan.
• Refer to “Failure codes” parts
(page 7-1)
• See “the adjusting your oven temperature”
in owners manual
PROBLEMS POSSIBLE CAUSES & FAULTS SOLUTIONS
To Next Page
Loading...
Need help?
General
