ENGENGLISH
33
INSTALLATION MENU
Clock Setup
Clock Display
(Except for UV34**)
-
You can select ‘YES’ or ‘NO’ by pressing button.
-
After selecting ‘YES’, you can see the LED Clock TV.
Dimming Standby
(Except for UV34**)
-
Standby Dimming value Range : 0~15 (Only UW76**, UW95**)
-
Standby Dimming value Range : 1~2 (Only LV75**)
Dimming PowerOn
(Except for UV34**)
-
PowerOn Dimming value Range: 0~99 (Only UW76**, UW95**)
-
PowerOn Dimming value Range: 1~5 (Only LV75**)
Clock Source
-
You can select ‘Off’, ‘Pro:Centric’, ‘TV’, ‘NTP’, ‘Admin’ by pressing button.
-
NTP : Clock is synchronized using Network Time Protocol. It's only enabled when network cable is connected.
-
Admin : It's automatically set to Admin when clock is updated by commercial protocols like TVLink-HCEC, TVLink-
Interactive, or HCAP API.
y
Input (Depending on model)
-
You can select 'Input' according to 'Clock Source'.
-
You can select 'RF' or 'IP' when Clock Source is 'Pro:Centric'.
-
You can select TV source when Clock Source is 'TV'.
-
Input is set to 'None', 'HCAP', 'Protocol', 'HTNG' automatically when Clock Source is 'Admin'.
y
Program/Frequency (Depending on model)
-
Sets the Frequency to get the time information when Clock Source is 'Pro:Centric'.
-
You can select Program when Clock Source is 'TV'
y
Timezone(City) /Timezone(Custom) /Timezone(Offset) (Depending on model)
-
In the case when there is difference between the time information received from the Teletext and the time of the current
area, it can be set up to correct this. The initial value is 0, and it can be changed in the range of -12Hrs ~ +14Hrs. (
Timezone(Offset) range is -12Hrs ~ +12Hrs )
To Next Page
Loading...
Need help?
General
