LG MULTI V IV PRO ARUV100LLS4 - Page 67

ELECTRICAL WIRING
67
ENGLISH
* Functions save in EEPROM will be kept continuously, though the system power was reset.
Setting the function
Select the mode/function/option/value using ‘▶’, ‘◀’ Button and confirm that using the ‘●’ but-
ton after dip switch No.5 is turned on.
DIP-SW01 7 - Segment
SW01C ( : confirm)
SW02C (ඔ : backward)
SW03C (ඖ : forward)
SW04C (
: cancel)
SW01D (reset)
MODE FUNCTION OPTION VALUE ACTION
remarks
content Display1 content Display2 content Display3 content Display4 implement Display5
Install
ation
Cool & Heat Selector oFF op1~op2
selected
the option
- -
change the
set value
blank
save in
EEPROM
Static pressure compen-
sation
oFF op1~op3
selected
the option
- -
change the
set value
blank
save in
EEPROM
Night low noise oFF op1~op15
selected
the option
- -
change the
set value
blank
save in
EEPROM
ODU address - - 0~254
set the
value
change the
set value
blank
save in
EEPROM
Target pressure auto ad-
justing
oFF op1~op6
selected
the option
- -
change the
set value
blank
save in
EEPROM
High Efficiency
Cooling
oFF on
selected
the option
- -
change the
set value
blank
save in
EEPROM
Auto dust removal oFF on
selected
the option
--
change the
set value
blank
save in
EEPROM
Low ambient kit oFF on
selected
the option
--
change the
set value
blank
save in
EEPROM
Compressor Frequency
Limitation
oFF op1~op9
selected
the option
--
change the
set value
blank
save in
EEPROM
ODU fan Limitation oFF op1~op7
selected
the option
--
change the
set value
blank
save in
EEPROM
Smart Load Control oFF op1~op3
selected
the option
--
change the
set value
blank
save in
EEPROM
SVC Continuous cooling oFF op1~op3 ---
change the
set value
blank
-