LG MULTI V S ARUV060GSD0 - Control Box and Connecting Position of Wiring

ELECTRICAL WIRING
49
ENGLISH
Control box and connecting position of wiring
- Remove all of the screws at side panel and remove the
panel by pulling it forward.
- Connect communication cables between outdoor unit and
indoor units through the terminal block.
- When the central control system is connected to the out-
door unit, a dedicated PCB must be connected between
them.
- When connecting communication cable between outdoor
unit and indoor units with shielded cable, connect the
shield ground to the earth screw.
Side panel
ON
L1 2 3 4
KSDO4H
ON
L1 2 3 4
KSDO4H
ON
L1 2 3 4
KSDO4H
ON
L1 2 3 4
KSDO4H
PI 485
PI 485
PI 485
PI 485
Bracket
WARNING
The temperature sensor for outdoor air should not be exposed to direct sunlight.
- Provide an appropriate cover to intercept direct sunlight.
!
※Pictures may differ depending on the model.
6HP 5HP
3/4HP 2.5HP