36
MultiSITE CRC 2 Controller
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
ACCESSORIES INSTALLATION
Water Leak Sensor Installation
1. Place the sensor on the floor in a location where water leakage will be detected
soon after the leak starts. For example:
• At the side of a bath tub or vanity unit to detect overow from the tub or sink.
• Beneath a hot water radiator control tap.
• Near a water pipe or tap to detect leakage.
2. Ensure that the sensor is placed so that the sensing pads are in contact with the
floor.
3. Avoid locations where the sensor may be accidentally kicked or otherwise moved.
The best locations are on the floor in corners, or beneath cabinets or other
fixtures.
Figure 40: Water Leak Sensor Installation
To Next Page
Loading...
