LG PREMTA200 - Air conditioner; Ventilator setting

21
SETTINGS
Function
Description
Note & Option
Display Opposite
Mode
This is a function to set whether to display the operation mode
selection impossible status according to the operation of the outdoor
unit when the cooling/heating mode is selected for products that do
not support simultaneous cooling/heating operation.
On / Off
Password
Set the password to prevent unauthorized change to remote controller
settings.- If the password is set, when you enter “menu – setting”,
you need to input password toenter the setting list.- When you forgot
the password, you can initialize the password using the installer
setting’s“password initialization”.The initialized password is “0000”.
-
Remote
Controller Wi-Fi
Pairing
This function executes the pairing function of theWi-Fi module
connected to ThinQ App.
Auto return to
main screen
This is a function to set whether to automatically return to the main
screen when there is no touch input for a certain period of time.
On / Off
Sound
Activate touch button sound effect
On / Off
Air conditioner / Ventilator setting
Function
Product
Description
Option
Aircon
Vent.
Vane Angle
control
O
You can adjust the angle of the wind.
All
All vanes operate the
same at the set angle.
Each/Customize
The angle for each
vane can be set
individually.
individually.
individually.
Standard
Vanes are controlled as
standard movements for
each product.
each product.
each product.
Elevation Grill
O
When cleaning the indoor unit filter,
move the elevation grill up and down.
move the elevation grill up and down.
Up / Stop / Down
Robot
Cleaning
O
After using the air conditioner for a
certain period of time, it is the cleaning
function of the kit attached to the
product.
Available after 30 seconds of operation
stop, select whether to operate
automatically as an option.
automatically as an option.
Automatic : Automatically performs after 30 hours of accumulated indoor unit
operation.
Manual : Performs manually.
Auto Dry
O
When the product is turned off after
cooling operation, mold or moisture
can be removed by drying the inside of
the room.
ON/OFF
Filter Sign
O
O
You can check the information
remaining afterusing the filter and reset
the usage time.
Note that filter use information is a reference item, that the actual filter status
may vary depending on the installation environment and usage conditions.
•
If dust gets on the filter, the cooling/heating ability decreases and the
electricity bill is high, so make sure to clean the filter when it is time to clean
it.
Change
Temperature
O
O
In Auto operation mode, the cooling
and heating operation is automatically
converted and operated according to
the set temperature.
the set temperature.
Dead Band
O
This function sets the minimum
difference between heating and cooling
desired temperature in 2set Auto mode.
desired temperature in 2set Auto mode.