15
OPERATION
ENGLISH
OPERATION
Operation Overview
Using the Appliance
Before the first cycle, set the appliance
to dry for 5 minutes to warm up the
drum. Open the door between loads the
first few times you use the appliance to
allow any odours from the interior of the
appliance to disperse.
Children must be supervised so that
they do not climb inside the drum.
1
Ensure the lint filter and water
container are clean.
• Open the door and ensure the lint
filter is clean. When the filter is full
with lint, drying times will be longer
than usual.
• Pull out the water container and
empty the condensed water. When
the water container is full, the
appliance may stop during the
cycle.
• In some instance, LED window may
display
E
icon to inform you that the
water container is full. If this occurs,
empty the water container.
2
Place the clothes into the drum after
sorting and close the door.
• Push the clothes deep into the drum
so that the clothes keeps away from
the door seal. When the clothes get
stuck between the door and seal,
they may get damaged while
drying.
• The clothes should be sorted by
fabric types and dryness level.
• All strings and attached belts of
clothes should be well tied and fixed
before being put into the drum.
3
Choose a drying programme by
turning the programme selector
knob.
4
Press the
Start/Pause
button to start
the drying programme.
• When you press the button, the
appliance ventilates the inside of
the drum for 10 seconds in order to
get the appliance ready for drying
operation.
• The appliance washes lint, which
builds up onto the surface of the
condenser, automatically using water
that is condensed from the clothes
during operation.
• The frequency of cleaning condenser
may vary depending on the size and
the initial moisture amount of the
clothes.
5
After the drying programme has
finished, open the door and unload
the clothes.
To Next Page
Loading...
