1-5
1. Press (POWER).
The initial setup wizard appears on the screen.
2. Use c/d/e/f to select a display language and
press ENTER (~).
3. Read and prepare the preparations for the network set-
tings and then press ENTER (~) while [Start] is highlighted.
If wired network is connected , the network connection
setting will automatically be fi nished.
4. All available networks are displayed on the screen.
Use c/d to select [Wired Network] or desired SSID of
wireless network and press ENTER (~).
If you have security on your access point, you need to
input the security code as necessary.
5.
Use c/d/e/f to select the IP mode between
[Dynamic] and [Static]. Normally, select [Dynamic]
to allocate an IP address automatically
6. Select [Next] and press ENTER (~) to apply network
settings.
Network connection status is displayed on the screen.
For details on network settings, refer to O/M for “Con-
necting to your Home Network”.
7. Select [Next] and press ENTER (~).
Read and prepare the preparations for the wireless
speaker setting.
8. Select [Next] and press ENTER (~).
9. Press ENTER (~) to verify the test tone signals of
the speakers.
After verifying the test tone signals, press ENTER (~)
while [Stop] is highlighted. Select [Next] and press EN-
TER (~).
10. Check all the settings that you have set in the previ-
ous steps.
Press ENTER (~) while [Finish] is highlighted to fi n-
ish the initial setup settings. If there is any settings to
be changed, use e/f to select [Previous] and press
ENTER (~).
INITIAL SYSTEM SETUP
When you turn on the unit for the fi rst time, the initial setup wizard appears on the screen. Set the display language,
network setting and speaker setup on the initial setup wizard.
To Next Page
Loading...
Need help?
General
