LG SH4 - Page 9

1-8
1. Preparation
- Display Jig (EAX66734601)
- Remote control.
- Do format USB Memory to FAT32 File system.
- USB : Update fi le exist only in the USB Memory stick.
Ex ) SH4 :
MCS  E:\PG540_SH4_*.bin (if USB driver is E:\)
EQ  E:\EQ_PRG_*.BIN (if USB driver is E:\)
Wireless Tx  E:\WIRELESS_TX.bin (if USB driver is E:\)
Wireless Rx  E:\WIRELESS_RX.bin (if USB driver is E:\)
2. Update
1) Connect Display Jig to Main CN501 connector.
2) Power on.
3) Select the USB function (USB Mode).
4) Insert USB.
5) Display in Display Jig VFD.
MCS : “FW UP”  “FINISH”  Power off.
EQ : “EQ UP”  “FINISH”  Power off.
Wireless Tx : “UPDATE”  “TX XX”(Progress)  “FINISH”  Power off.
Wireless Rx : “UPDATE”  “RX XX”(Progress)  “FINISH”  Power off.
6) Loading is shown while updating.
Never remove USB or AC cord.
7) After update fi nish, show FINISH in VFD and power off automatically.
8) Power cord un-plug.
MCS / EQ PROGRAM UPDATE GUIDE