- 5 -
Copyright ©2013 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Safety Precautions
Two or more people must lift and
transport the product.
• Avoid personal injury.
Do not install the product where
it will be exposed to sea wind
(salt spray) directly.
• It may cause corrosion on the
product.
Install the drain hose to ensure
that the condensed water is
drained away properly.
• A bad connection may cause water
leakage.
Do not step on or put anyting on
the product. (outdoor units)
• There is risk of personal injury and
failure of product.
Do not insert hands or other
objects through the air inlet or out-
let while the product is operating.
• There are sharp and moving parts
that could cause personal injury.
Be cautious when unpacking and
installing the product.
• Sharp edges could cause injury.
Keep level even when installing
the product.
• To avoid vibration or noise.
Do not install the product where
the noise or hot air from the out-
door unit could damage or dis-
turb the neighborhoods.
• It may cause a problem for your
neighbors and hence dispute.
Always check for gas (refriger-
ant) leakage after installation or
repair of product.
• Low refrigerant levels may cause
failure of product.
Do not use the product for spe-
cial purposes, such as preserv-
ing foods, works of art, etc. It is a
customer's product, not a preci-
sion refrigeration system.
• There is risk of damage or loss of
property.
Do not block the inlet or outlet of
air flow.
• It may cause product failure.
Use a soft cloth to clean. Do not
use harsh detergents, solvents
or splashing water etc .
• There is risk of fire, electric shock,
or damage to the plastic parts of
the product.
If the refrigerant gas leaks dur-
ing the repair, do not touch the
leakaing refrigerant gas.
• The refrigernat gas can cause
frostbite (cold burn)
Do not mix air or gas other than
the specified refrigerant used in
the system .
• If air enters the refrigerant system,
an excessively high pressure
results, causing equipment damage
or injury.
If the refrigerant gas leaks during
the installation, ventilate the area
immediately.
• Otherwise it can be harmfull for
your health.
The refrigerant of this product is R410A.
• The installation tool such as manifold gauge should be complied with R410A.