Accessories Installation
Installation Manual 65
ENGLISH
How to Wire Sanitary Water Tank Heater
Step 1. Uncover heater cover of the sanitary water tank. It is located side of the tank.
Step 2. Find terminal block and connect wires as below. Wires are field-supplied item.
(L) : Live signal from PCB to Heater
(N) : Neutral signal from PCB to Heater
Wire specification
• Cross-sectional area of the wire should be 5mm
2
.
Adjusting thermostat temperature
• To guarantee proper operation, it is recommended to set temperature of thermostat to maximum
temperature (symbol at the picture).
To Next Page
Loading...
