To Next Page

To Previous Page

Connecting the Display

Important

This illustration depicts the general model of connection. Your monitor may differ from

the items shown in the picture.

Do not carry the product upside down holding only the stand base. The product may

fall and get damaged or injure your foot.

Before setting up the monitor, ensure that the power to the monitor, the computer

system, and other attached devices is turned off.

Connecting the stand

1. Place the monitor with its front facing downward on a soft cloth.

2. Assemble the Stand Body into the product in the correct direction as shown in the picture.

Make sure you push it until you hear it “click”.

3. Assemble the Stand Base(Front, Rear) into the Stand Body in the correct direction.

4. Once assembled take the monitor up carefully and face the front side

Stand Base

Hinge Body

Stand Body

Questions and Answers:

Need help?

Do you have a question about the LG W2242T and is the answer not in the manual?

LG W2242T Specifications

General

Pixel pitch	0.282 x 0.282 mm
Aspect ratio	16:10
Display diagonal	22 \
Display resolution	1680 x 1050 pixels
Vertical scan range	56 - 75 Hz
Horizontal scan range	30 - 83 kHz
Contrast ratio (typical)	-
Display brightness (typical)	250 cd/m²
Special features	sRGB, HDCP, Flatron f Engine, Intelligent Auto, Auto resolution, 4:3 in Wide (ARC)
Power requirements	90 – 264 Vac, 47 – 63 Hz
Display viewable area (HxV)	473.86 x 296.16 mm
HDCP	Yes
Certification	TÜV-Typ, CE, EPA Energy Star, UL, CSA, SEMKO, FCC-B, TCO03
Product color	Black
Compliance industry standards	DDC 2B
LED indicators	Stand-by
Tilt angle range	-5 - 20 °
Panel mounting interface	75 x 75 mm
Power consumption (standby)	0.3 W
Power consumption (typical)	22 W
Sustainability certificates	ENERGY STAR

Weight and Dimensions