8
Installation
■ Removing packing
■ Removing transit bolts
To prevent internal damage during transport, the 4 special bolts are locked. Before operating the washer,
remove the bolts along with the rubber bungs.
If they are not removed, it may cause heavy vibration, noise and malfunction
•
Packaging material (e.g. Films, Styrofoam) can be dangerous for children. There is a risk of suffocation
! Keep all packaging well away from children.
• Keep the spanner provided for future use.
WARNING
NOTE
• Keep the transit bolts for future use.
NOTE
1.
Remove the cardboard box and styrofoam
packing.
2.
Lift the washing machine and remove the base
packing. This will require 2 or more people or
a lifting device.
3. Remove the tape securing the power supply
cord and drain hose.
4. Remove the inlet hoses from the drum.
1.
Unscrew the 4 bolts with the spanner supplied.
2. Take out the 4 bolts along with the rubber
bungs by slightly twisting the bung.
3. Close the holes with the caps supplied.
Washer
Base Packing
Spanner
Transit bolt
To Next Page
Loading...
Need help?
General
