LG WD14060D6 - Troubleshooting with Error Codes; IE (Water Inlet Error)

27
7-7. TROUBLESHOOTING WITH ERROR CODES
IE (Water Inlet Error)
Reconnect or repair the Connector.
Or replace the Harness.
Is the Connector connected correctly to the Main PCB
and the Inlet Valve? Is the Harness alright ?
NO
Is the water tap closed?
[Note] Environmental safety check list
1. No water tap leakage or freeze 4. No entanglement of water supply hose.
2. No water shortage. 5. No water supply hose leakage
3. The inlet filter is not cloggeed.
Check the Water tap and open it fully.
When there is water in the tub,
is the water level frequency
over 26.0khz?
Are the inlet valve filters
clogged?
Check the Air Chamber and the Tube (clogged)
Check the water level frequency again,
if it is over 26.2KHz, replace the Pressure switch.
YES
YES
YES
NO
NO
NO
There are filters on the unit’s inlet valves to filter mineral
deposits or other debris from entering the unit.
If it is clogged, water will not flow through these filters. Remove
hoses from unit, remove the filters and clean thoroughly.
1 2 3 4 5
Replace the Inlet Valve.
NO
Replace the Main PCB.
NO
YES
YES
Is the resistance of each lnlet valve within 3.5 ~4.5 kΩ ?
When the washing machine is started, is the inlet valve
operating?
Pre Valve
Steam Valve
Main Valve
1 2
1
2
3
3