16
No. Process Explanation
A.
Intermittent
spin
•To reach the correct set speed, the motor rotates clockwise and
counterclockwise directions after spin process starts.
• If the water level frequency is lower than 23.0 kHz, a washer senses
suds and starts suds removal process.
B.
Rinse
spin
• In this process, the remaining water during washing process is
extracted and the selected speed is kept.
• Removing suds process is in active mode at this cycle.
C.
Remaining
spin
•
After spin finishes, the drum rotates by remaining spin power until it stops.
Motor power is off.
• This process is overlapped with next process.
D.
Rinse water
supply
•Water supply for rinse process
E.
Rinse • Rinsing process.
F.
Last
drainage
• After spin finishes and power is not supplied to motor, the drum
rotates by remaining spin power
• If rinse hold is selected, the drainage is not proceeded after rinse
finishes.
G.
Disentangling • The same as item 9.
H.
Intermittent spin
• The same as item A.
I.
Main spin1 • The same as item B.
J. Main spin2 • At the end of a main spin, the spin speed will reach the selected rpm.
K. Remaining spin • The same with item C.
L. Disentangling • After spin finishes, disentangling starts to remove unbalanced
laundry.
M. End • After 'end' signal is displayed, it stays for 8 seconds and power is
automatically turned off. (Auto type door switch)
• After door switch is off, end signal is displayed in the case of
manual type and it takes around 2 minute to turn off door switch.
To Next Page
Loading...
Need help?
General
