LG WM2240C series - Unpacking and Removing Shipping Bolts

E
N
G
L
I
S
H
I N S T
A L L A
T I O N
I N S T R U C T I O N S
When removing the washer from the
carton base,
be sure to remove the foam tub support in the
middle of the carton base.
If you must lay the washer down to remove the
base packaging materials, always lay it carefully
on its side. Do NOT lay the washer on its front or
back.
IMPORTANT:
To prevent internal damage during
transport, the washer is equipped with 4 shipping
bolts and plastic retainers. These bolts and
retainers
MUST
be removed before operating the
washer.
•
Failure to remove shipping bolts and
retainers
may cause severe vibration
and noise, whi
ch can
lead to permanent damage to the washer. The
cord is secured to the back of the washer with
a shipping bolt to help prevent operation with
shipping bolts in place.
Starting with the bottom 2 shipping bolts,
use the included wrench to remove the
4 shipping bolts by turning them
counterclockwise.
2
Remove the retainers by turning them slightly
while pulling. Rotate and press the hole caps
into the shipping bolt holes.
NOTE:
Save the bolts and retainers for
future use. To preve
nt damage t
o internal
components, the shipping bolts and
retainers must be installed when
transporting the washer.
1
Retainer
Hole Cap
UNPACKING AND REMOVING SHIPPING BOLTS
Carton Base
Foam Tub
Support
Shipping
Bolts
11