16
INSTALLATION
Connecting Screw-Type Hose to Tap
Without Thread
1. Loose the four fixing screws (
1
).
2. Remove the guide plate ( ) if the tap is too
large to fit the adapter.
3. Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws.
4. Push the supply hose ( ) vertically upwards
so that the rubber seal within the hose can
adhere completely to the tap and then tighten
it by screwing it to the right.
Connecting One Touch Type Hose to
Tap Without Thread
1. Unscrew the adapter ring plate ( ) and loose
the four fixing screws.
2. Unscrew the adapter ring plate ( ) and loose
the four fixing screws.
5
To Next Page
Loading...
