17
INSTALLATION
3. Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws and
the adapter ring plate.
4. Pull the connector latch plate ( ) down, push
the supply hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
6
NOTE
• Before connecting the supply hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and
etc.) in the water lines. Let the water drain into
a bucket, and check the water temperature.
Connecting Hose to Appliance
Screw the water line to the water supply on the
back of the appliance.
NOTE
• After completing connection, if water leaks
from the hose, repeat the same steps. Use the
most conventional type of tap for the water
supply. If the tap is square or too big, remove
the guide plate before inserting the tap into
the adaptor.
• Please make sure that the hose has no kinks
and is not trapped.
To Next Page
Loading...
