46
TROUBLESHOOTING
Problem Reason & Solution
Washing machine
does not start.
Electrical power cord may not be plugged in or connection may be
loose.
• Reconnect the power cord and make sure plug fits tightly in
electrical outlet.
House fuse blown, circuit breaker tripped, or a power outage has
occurred.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity.
If problem is a circuit overload, have it corrected by a qualified
electrician.
Water supply tap is not turned on.
• Turn on water supply tap.
Duration is delayed. If an unbalance is detected or if the suds removing programme is
on, the wash time will increase.
• This is normal. The time remaining shown in the display is only an
estimated duration. Actual time may vary.
Fabric softener overflows
/ Fabric softer is rapidly
dispensed.
Too much fabric softener may cause an overflow.
• Follow softener guidelines to ensure appropriate amount is used.
Do not exceed the maximum fill line.
Fabric softener dispenses too early.
• Follow the guidelines provided by the detergent manufacturer.
Close the dispenser drawer slowly. Do not open the drawer during
the wash cycle.
Excessive foaming occurs. Too much detergent or unsuitable detergent may cause excessive
foaming which may result in water leaks.
• Make sure that the suggested amount of detergent is according to
the manufacturer’s recommendations.
To Next Page
Loading...
