4-4. ADJUSTMENT
1) B ra k e le v er a dju st m e n t
screw to keep clearance less than 1.9°æ0.1mm
between the tip and the brake lever.
And turn on the lock nut then paint it red.
Painting part is adjusted in factory, it does not
need adjusting.
Adjust the screw properly if the brake doesn't
work during spin.
CAUTION
2) K eeping clea r an ce
Keep the clearance about 2.0~3.5mm between
Clutch pulley must be turning to one side P.V
Link is pulling the brake Lever.
Clutch pulley must be turning to the left and the
right when P.V Linke does not pull the brake
Lever.
CAUTION
3) V -belt adjustm e n t
ey by pushing the motor like
arrow
, to make V-belt tension parallel when
pushed at the point of arrow
.
When the V-belt is not properly adjusted, the
motor will not be running or the belt will be
slipping.
CAUTION
26
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
To Next Page
Loading...
