4-5. DIS A SSE M BLY IN S TR UCTION
Be sure to unplug the power to repair and
replace electric parts.
1) D is a ssem bly of Fro n t Pa ne l
& PCB A ss e m bly
Remove two screw caps using a sharp tool
Push the front panel to the left side then
pull it out.
Disconnect the leads from the controller.
Remove 4 screw from the front panel.
Remove the PCB Assembly.
Fuse is located in the Noise lter For fuse
use the following rated fuse
* Rating of fuse
- 250V 6.3A
Be sure to make earth connection for trouble
diagnosis and parts replacement. If impossible,
touch earth wire on the body to remove electric
deviation between the body and product before
work.
CAUTION FOR ELECTROSTATICS
27
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
To Next Page
Loading...
