11) S pin in g is go in g o n ev en t h o ug h t he lid is o pe n .
43
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Ball Pressure Sensor
1. Is placed the magnetic on the wash?
Yes
No
Reed S/W is short
by magnetic on
the washer.
Reed Switch.
Keep magnet away from
the washer.
Change the controller.
12) S pin ba sk e t do e sn’t rea ch t o f u ll spe e d ( n o rm a l rpm )
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Main v
oltage
1. Check voltage at the power outlet
where the washer is plugged into.
Clutch Assembling
1. Check the clearance between the
PV link and the brake lever and
clearance between the clutch lever
and the adjustment bolt.
Blocked by foreign objects
1. Check whether the PV asm, the
drain pump & the drain hose are
blocked by foreign objects so that it
makes water-splashing noise in the
tub.
Less than
85% of rating
The clearance is
less than 2.0
mm
or more than 3.5
mm
Bolt clearance is
out of range
1.9 0.1mm
Tool low voltage
Defect of the
clutch
Explain the cause and
recommend using a
transfomerformer if
necessary.
Adjust PV lever bolt and
paint it red.
Reassemble the drain
motor or the clutch.
Adjust the bolt
clearance.
Remove the foreign
objects.
To Next Page
Loading...
