LG WT19WSBP - Page 44

13) V ibr a tio n, N oise o r Unba la nce E r ro r h a ppe ns dur in g spin .
44
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Using conditions suc
h as
installation etc.
1. Check whether the washer is
leveled. (Check clearance with out
tub and out case the left gap is the
same as the right and the rear gap is
1.5~2 time bigger than the front gap,
between the cabinet and the wash
bowl, when it is leveled.)
2. Check whether laundry in the wash
bowl is out of balance that can
cause severe vibration & noise.
3. Check whether the pulsator doesn’t
rotate during spin.(To check that,
remove the front lid and than run the
spin only cycle.)
Damper
1. Check whether the outer tub cover
hit the top cover without load
during spin.
Not leveled.
Laundry is
unbalanced.
The pulsator
rotates initially
then the inner tub
rotates.
Hit
Defect of
installation
Defect of the
clutch
Defect of the
damper
Level the washer.
Explain that it is not out
of order and it may
happen when big & long
laundry is washed.
Change the clutch
spring-B or the clutch
asm.
Change four dampers
simultaneously.
(In assembling, check
the position to damper
asm)
noise during spin and accumulately service experiance.