USER MANUAL - SS0407E / SS0507E / SS0607E / AS0607 / AS0607W / AS0607WE / AS0607E / AS0608 / AS0608E
31
Chapter 7 - Workstation inspection
7.1 Prohibited from operating unless
The safety principles of the machine are understood and implemented.
1) Dangerous conditions are avoided.
2) The inspection before operation is always carried out.
The workstation inspection is understood and followed up for the next step.
3) The workstation has been checked.
4) A function test is always carried out before use.
5) The machine is used for its designed purpose.
7.2 Basic principles
1)
The workstation inspection allows the operator to determine whether it is safe enough to operate the machine.
The operator performs this process before the machine is moved to the workstation.
2) Understanding and taking responsibility for the dangers of the workstation is the responsibility of the operator.
Be careful and avoid problems in the process of transfer, installation and operating the machine.
7.3 Workstation Inspection
Be careful and pay attention to the following risks:
1) Abrupt incline or holes
2) Unevenness, ground obstruction or debris
3) Inclined surface
4) Defective or slippery surface
5) Overhanging obstacle and high-voltage cable
6) Dangerous location
7) Surface support cannot support all machine loads
8) Wind and Weather
9) Non-authorised personnel
10) Other possible unsafe conditions
To Next Page
Loading...
