LGMG AS0607 - Compliance and Follow-up for Transport; Transport Safety

www.lgmgeurope.com
AS0808 / AS0808E / AS0812 / AS0812E / AS1012 / AS1012E / AS1212 / AS1212E / AS1413
38
Chapter 10 - Transport and lifting instructions
10.1 Compliance and follow-up
1) If you lift the machine with a crane, make the correct assessment and draw up a plan for moving the
machine.
2) Only personnel qualied for above-ground lifting may load and unload the machine.
3) The transport vehicle must be parked on a level surface.
4) When loading the machine, secure the vehicle to prevent movement.
5) Make sure that the vehicle volume, load surfaces, chain or belt are sufcient for carrying
the machine weight. Refer to the type plate for the machine weight.
6) Make sure the machine is on a horizontal surface or secure the machine before the brake is released.
7) Take measures to prevent the protective rail from falling when removing the bolt. Hold the
protective rail securely when folding the protective rail.
8) Do not drive the machine up and down an incline. Do not operate the machine on an incline that is too steep.
For "driving on a incline", see the "Operation notice!".
9) If the incline exceeds the maximum incline percentage, you must load and unload the machine with a winch
according to the brake operation instruction.
10.2 Transport safety
1) Lock the machine wheels during preparation
for transportation.
2) Pull in the extended platform and secure it.
3) Turn the ignition key to the "OFF" position and pull the key out
of the ignition for transport.
4) Fully inspect the machine for loose or
unsecured parts.
5) Secure the machine to the transport surface via the
anchoring part on the chassis.
6) Use at least four chains or belts.
7) Make sure you have used chains or belts with
sufcient load density.
8) For transport, fasten the folded protective rail
(if present) with a belt.
Compliance and follow-up
1) Only a qualied operator may use the lock
mount and lift the machine.
2) Only personnel with the qualication for forklift operation
may load and unload the machine with a fork-lift truck.
3) Make sure that the lifting capacity, the loading surface,
the belt or rope of the crane is sufcient for the
carrying the machine weight. The serial number can be
found on the type plate.