LGMG AS0607 - Chapter 10 - Transport and Lifting Instructions; Forklift Transport; Lifting Guidelines

USER MANUAL - SS0407E / SS0507E / SS0607E / AS0607 / AS0607W / AS0607WE / AS0607E / AS0608 / AS0608E
39
Chapter 10 - Transport and lifting instructions
10.3 Forklift
1) Make sure you securely and reliably secure the extended platform, controls and chassis drawer.
Remove all movable parts from the machine.
2) Lower the platform completely. Keep the platform folded in each transport process.
3) Use the forklift openings on both sides of the ladder.
4) Place the fork of the forklift into the forklift openings.
5) Drive the forklift forwards to fully insert the fork into the openings.
6) Raise the machine 15 cm and tilt the fork slightly backwards to keep the machine stable.
7) Keep the machine horizontal while lowering the fork.
Notice: Damage to parts may occur when lifting the machine
from the side.
10.4 Lifting guidelines
1) Lower the platform completely. Make sure that you secure and
correctly secure the extended platform, controls,
and chassis drawer. Remove all movable parts of the machine.
2) Connect the latch only to the specied lifting point
on the machine. Two lifting points must be available
at each end of the machine.
They can be used for lifting.
3) Adjust the locking tool so that the machine does not
get damaged and remains horizontal.
10.5 Parking and storage
Follow the parking and storage instructions below:
1) Drive the machine to a well-protected and well-ventilated ventilation area.
2) Make sure that the work panel is completely lowered.
3) Set the red emergency stop switch to the "OFF" position.
4) If necessary, cover the control panel and warning signals to protect them from serious environmental
conditions.
5) If the machine has been parked for a longer period of time, cover the wheels on both sides with a bafe plate.
6) Switch the power switch to the “OFF” position and remove the key from the ignition to prevent starting and
unauthorised use of the equipment.
7) If the optional anti-breakage equipment is provided, the work panel and ground control box can be
covered and locked to prevent access.