LGMG AS0607 - Entrapment Risk; Risk While Working on an Incline; Risk of Falling; Danger

USER MANUAL - SS0407E / SS0507E / SS0607E / AS0607 / AS0607W / AS0607WE / AS0607E / AS0608 / AS0608E
9
Chapter 1 - Safety
25) Do not use a battery with a weight lower than the original battery. The battery is not only used as a weight
balance in the chassis, but also plays an important role in stabilising the machine.
Each battery should reach 37 kg respectively. The minimum weight of each battery drawer (including the battery)
should reach 110 kg, respectively.
26) Do not place stairs or scaffolding in the platform or lean them against part of the machine.
27) The tools and materials, should be evenly distributed and safely placed by the person on the platform.
28) Do not use the machine on a movable surface or vehicle.
29) Keep all tyres in good condition and tighten the nuts properly.
1.10 Entrapment Risk
1) Do not extend your arms and hands so that there is a risk of abrasions or entrapment.
2) If the machine is lifted via a control on the ground, you must make the correct and planned assessment.
Maintain the safe distance between the operator, machine and the attachment part.
1.11 Risk while working on an incline
Do not drive the machine on a slope or a side slope that is too steep. The nominal value of a slope applies to the
lifting machine.
1.12 Risk of falling
1) The employees on the platform must carry out all safety measures in the operating process and attach a
safety harness with the safety-belt hook. One fork ts at each anchorage point.
2) Do not climb or sit on the protective rail of the platform. Always stand stable on the base plate.
3) Do not climb off the platform when it is raised.
4) Keep the platform oor free of dirt.
5) Close the entrance door for the operation of the aerial platform.
6) Do not use the machine if the protective rail is not installed correctly and safe operation cannot be ensured
through the access door.
7) Do not climb on and off the platform unless the machine has not fully descended.
1.13 Danger
1) Pay attention to the items within the eld of vision and the danger zone when driving/lifting the machine.
2) Pay attention to the position of the extended platform when moving the machine.
3) Check the workstation to avoid overhead obstructions or other potential risks.
4) Pay attention to the risk of crushing when holding the protective rail of the platform.
Type
SS0407E / SS0507E / AS0607 / AS0607W
AS0607WE / AS0607E / AS0808 / AS0808E
AS0608 / AS0608E / AS0812 / AS0812E
AS1212 / AS1212E / AS1413
AS1012 / AS1012E
Forwards
3 degrees
3 degrees
3 degrees
3 degrees
3 degrees
Backwards
3 degrees
3 degrees
3 degrees
3 degrees
3 degrees
Sideways
1,5 degrees
1,5 degrees
1,5 degrees
1,5 degrees
2 degrees