www.lgmgeurope.com
AS0808 / AS0808E / AS0812 / AS0812E / AS1012 / AS1012E / AS1212 / AS1212E / AS1413
10
Chapter 1 - Safety
5) The user must follow the maintenance rules for the personal protection equipment prepared by the owner, the
maintenance rules for the workstation and the laws added by the government.
6) Pay attention and follow the movement arrow and the direction of rotation on the platform control and the
platform label and nameplate.
7) Do not use the machine behind a crane or machine with upward movement, unless the crane control is locked
and/or the potential collision prevention measure has been taken.
8) Avoid dangerous driving or careless operation when the machine is running.
9) The platform can only be lowered when there are no people and obstacles underneath the platform.
10) Limit the driving speed based on the ground status, trafc, road situation, personal position and other
possible collision factors.
1.14 Risk of component damage
1) Do not charge the battery pack with a battery charger higher than 24V.
2) Do not use the machine as a ground wire during welding.
1.15 Explosion and re risk
Do not charge or operate the machine in a place with potentially ammable or explosive gas or gas particles.
1.16 Risk of machine damage
1) Do not use a damaged or defective machine.
2) Do an operation test and test all functions for each work period. Immediately place a mark on the damaged or
defective machine and stop operation.
3)
Make sure that all maintenance and operating work is carried out in accordance with the provisions of this manual.
4) Make sure you have all the labels in the right places and keep them legible.
5) Keep this manual in the document box of the platform.
1.17 Risk of personal injury
1) Do not use the machine in the event of a hydraulic oil leak. The leaked hydraulic oil can penetrate or burn
through the skin.
2) Serious injury can be caused if parts under the cover are accidentally touched.
Only trained service personnel can maintain the compartment. It is proposed that the operator performs
maintenance for the preinspection of the controls. Make sure that all compartments are closed and locked
during operation.
1.18 Battery safety
Risk of burns
1) The battery contains acid material. Wear protective clothing and goggles when using the battery.
2) Take measures against overowing or touching the acid material. Neutralise the overow acid material from
the battery with soda and water.
Explosion risk
1) Keep the battery pack away from sparks, ames or lit cigarettes.
The battery may release explosive gas.
2) Do not touch the battery terminal or cable clamp with tools that may cause sparks.
To Next Page
Loading...
