LI-COR LI-840A - Page 8

Using the Toolbar 3-6
Settings Window - Setting Operational Parameters 3-7
Enable Heater 3-8
Pressure Compensation 3-8
Filter 3-8
DAC Output 3-8
CO2 Span Range 3-13
Alarms 3-13
Using the Terminal Strip 3-14
Software Reference 3-16
Charting Window 3-16
Series 1 3-17
Series 2 3-17
X-Axis Max 3-17
Diagnostic Window 3-18
Logging Data 3-19
Start Logging 3-19
Stop Logging 3-20
Pause Logging 3-20
Options 3-21
User Calibration - Setting the Zero and Span 3-23
Two Point Span (Span 2 Tab) 3-26