Liebert ICOM - Page 68

Service Menu Parameters
62
Password PASSWORD W -
Alarm Relay ALM REL W Off, On
FC Relay FC REL W Off, On
3P Actuator Open 3P OPEN W Off, On
3P Actuator Close 3P CLOSE W Off, On
BV Control BV CTRL W Manual, Auto
Analog Out 1 ANALOG1 W 0-100%
Analog Out 2 ANALOG2 W 0-100%
Analog Out 3 ANALOG3 W 0-100%
Analog Out 4 ANALOG4 W 0-100%
Page 5 of 7
Status Remote Shutdown RSD R On, off
Status Airflow Loss AIR LOSS R OK, Act
Status Motor Overload MOTOR OL R OK, Act
Status Filter FILTER R OK, Act
Status Customer Input 1 CUSTOM 1 R OK, Act
Status Customer Input 2 CUSTOM 2 R OK, Act
Status Customer Input 3 CUSTOM 3 R OK, Act
Status Customer Input 4 CUSTOM 4 R OK, Act
Status Heaters Safety HEAT SAF R OK, Act
Loss of Airflow At FLOW AT W 0-100%
Actual Airflow FLOW ACT R 0-100%
Page 6 of 7
Status HP1 HP1 R OK, Act
Status LP1 LP1 R OK, Act
Status C1 OL C1 OL R OK, Act
Status HP2 HP2 R OK, Act
Status LP2 LP2 R OK, Act
Status C2 OL C2 OL R OK, Act
Table 27 Diagnostics / service mode parameters (continued)
Function
Read/
Write
Range
Imperial (metric)
Large Display Small Display
SERVICE