Liectroux N7S-U - Disassembly and Cleaning

12
2.2 Mop floor installation and use (some products with this function)
Insert the mop into the mop holder, align as shown in the figure, and paste the mop on
the magic tape of the water tank.
Place the bottom of the machine facing up, align the positioning column of the mop
holder with the positioning hole of the drag plate at the bottom of the machine, and
press the mop holder tightly.
2. Clean the 2-in-1 water tank/dust colletor subassembly
Clean the wet mop
2.1 Disassembly and cleaning
Clean water tank
After mopping the floor, please take out the water tank first, remove the mop
holder and the wet mop.Then rinse and dry the wet mop.
After mopping the floor, take out the water tank subassembly, and drain the
remaining water in the water tank.Then wipe the water on the water tank and
let it dry.