15
Warning code table
If the problems cannot be solved according to the above operation, please contact the after-sales service.
Ɣ Warm tips
If the above method does not solve the problem, please try the following:
1. Restart the power of the machine.
2. If the problem cannot be solved by restarting the machine, please send the machine to the
after-sales service center for maintenance.
Robot will emit a series of beeps when it is in trouble, and the red light will flash or keep on.
Beeps three times and the red
light keeps flashing
Ground sensor abnormal
Please check whether the ground sensor
is covered by dirt and wipe it clean.
1.
2.
3.
4.
5.
Beep once and the red light
stays on
Wheel is stuck
please check if there are anything in
the wheel gap and clean it up.
Beep once and the red light
keeps flashing
Front bumper is stuck
please check bumper Whether stuck
and clean foreign matter in it.
Beeps twice and the red light
keeps flashing
Side brush abnormal
please check whether the side brush
is entangled with hair and clean it up.
Beeps four times and the red
light keeps flashing
Power run out please charge it as soon as possible.
Machine keeps going
backwards
Abnormal cliff sensor
Please clean the surface of the cliff
sensor.
Machine skid
Robot fails to start
Robot shakes when
running
Abnormal operating
condition
The ground is too wet.
Please wring out the mop cloth and
clean the water stains on the floor.
Please contact our company for
after-sales maintenance.
Please charge the robot or turn on the
power switch.
The robot is out of power or the power
switch is off.
Side brush or caster tangled with hair.
The intake port is blocked or the dust
bin is full.
HEPA is blocked.
The outlet hole of the water tank is
blocked or the water tank has no water.
The pump does not work.
Water not coming out.
Please remove hairs from the side
brush or the universal wheel.
Please check the suction port and
clean the dust bin.
Clean or replace the HEPA
Please blow the water outlet and fill it
with water.
To Next Page
Loading...
